News
The three main parts of the mold temperature machine: circulation pump, heating pipe, and electronic control part. But on each machine there is a very conspicuous but uninteresting component-the filter. The filter function of the oil temperature machine is very simple. It filters the heat transfer oil or water and other media into the mold temperature machine.
Attention should also be paid to the use process:
First, make sure to use clean heat transfer media, such as water to use pure water, the heat transfer oil should be replaced every six months, so that the impurities passing through the filter are less likely to be blocked;
The piping of the two-mold temperature machine needs to be cleaned regularly. It should be cleaned once a month to clean up the internal impurities;
The filter screen cover of the three filters needs to be cleaned regularly, just remove it and remove it once a month to clean it.
Because the main part of the mold temperature machine is the pipeline, the filter is very important. Regular inspection and cleaning can ensure the smoothness of the pipeline and the life can be extended a lot.
If you do not pay attention to the filter, do not clean it regularly, or even install it, it may cause the pipeline to be impassable. The direct performance is that the circulation pump can not exert pressure. For a long time, the pipeline may be blocked, the heating pipe may be burned out, and repaired after repair. There is no way to repair it, so you must pay attention to the importance of the filter, not only to install it, but also to check it regularly.